PowerQuip Outboard Leg
PowerQuip Outboard Leg
Ideal for dinghies and Tenders, and very compact to store away when not in use. A very economical way to have a back up propulsion system on hand. Most small 33cc to 82cc 2 stroke weed eater type engines and 25cc - 52cc 4 stroke Honda GX clone/copy engines will bolt straight on. Raid the engine off your brush cutter or weed eater and head for the water!
The outboard leg is built with Aluminium and Stainless steel hardware, the body is solid alloy painted with epoxy black. The propeller is cast alloy, not plastic. The lower gearbox is a completely sealed unit, lubricated by marine grease. The unit is controlled via a tiller arm that has a twist throttle and on/off switch. Once the engine is started, throttle is required to activate the centrifugal clutch to engage the drive system.
Recommended for fresh water environments, if using in salt water proper after use care is required. A quick fresh water rinse of the leg and then a spray of CRC or INOX over the leg and engine is sufficient.
Check out the utube clip of the PowerQuip 4 Stroke outboard powering a tender around the marina: https://www.youtube.com/watch?v=ehhq64NO5gI
Outboard Leg Specifications:
- 185mm diameter propeller
- 600mm length from transom top to prop centre
- Tiller steer
- Adjustable trim
- Adjustable throttle
- On/off switch
- 4 Bolt pattern: 71mm across centres, 99mm diagonal centres
- Inside clutch housing diameter: 78mm
Shipping Dimensions: 94.5 x 20 x 16cm 5kg